• HOTLINE:
  • +86-020-22030508

0-10V interface actuator

8 fold 0-10v interface

0-10v interface,  relay can act with 0-10v, or  config to shutter/ blind/ switch actuator/ dry contact.

  • PERFORMANCEPARAMETER
  • Description
Power supply Operate voltage  21-30V DC
  additional power 24 DC,30Ma
  KNX bus current: <10mA
     
输出 Output 4/8 fold
  Part Number T/N BLC0406  T/N BLC0806
  Power consumer 5W/10W
  Relay switch Un 250 V AC(50/60Hz)
    In 6A
    Load Rate voltage        277VAC/30VDC
Rate current       
Resistor -- 10A
Fluorescent lighting load AX-- 4A
LED load  -- 0.5A
 
    Load circuit (relays) witching times1) electrical endurance to IEC 60 947-4-1              100,000  cycle
mechanical endurance  1,000,000 cycle
       
  0-10V interface Max current 100mA
    voltage 0-10V
    Max number for ballast 50PCS (2mA per ballast)
    Cable (100mA) 70 m with cable cross-section 0.8 mm2
100 m with cable cross-section 1.5 mm2
 connector   EIB/KNX 1 EIB bus terminal、1个24V DC additional power
Supply terminal
  Load for relay 2terminal per fold
  Cable for load Single core        0.2—4.0mm2
Finely stranded    0.2—2.5mm2
Enclosure IP20 to EN60529
Temperature range Operation – 5 °C ... + 45 °C
  storage – 25 °C ... + 55 °C
  transport – 25 °C ... + 70 °C
  Humidity Max 93%,moisture condensation should be excluded
housing PA66,gray color
Install 35mm DIN rail
SIZE 4 fold  T/N BLC0406  72×90×65mm(L × W × D)
  8 fold  T/N BLC0806  144×90×65mm(L × W × D)

The function of all channel is same:
0-10V:
——switch
Switch time.
Brightness for switch on
——relate dim
     Dimming time
     brightness limit
——brightness
    Dimming time
    Brightness limit
    Dimming time can be set by OBJECT via bus.
——Preset
     4 preset
——scene control
     8 scene
——force operate
     Brightness when for operate
     Brightness after bus voltage recover
——Output dimming profile setting
——Staircase lighting
——manual key
Short press:switch
Long press:dimming
——Brightness after bus voltage recover
——status feedback
 
 
Relay operate:(switch actuator、work with 0-10V、shutter/BLIND、dry contact output )
Switch actuator:
——status feedback
——Time function:(cycle、switch delay、staircase lighting)
     delay:
     ——Time for switch on/off delay
     cycle:
     ——Time for switch on/off delay
     ——cycle time
     ——switch on/off status setting after cycle
     Staircase lighting:
     ——time  endurance
     ——warning
——scene:
 
Work with 0-10V
Switch on/off according to 0-10V
 
Shutter/BLIND
note:only channel A、C、E、G can choose this function,
——shutter / blind choice
——scene
——status feedback
 
Output dry contact
——The time for output plus setting